Skip to content

Guide

Tempo training for beginners: how to read, write, and teach it

Most tempo pages stop at what the digits mean. This one adds a four-week ladder, the cues to say out loud, and the load rule, because slow reps make the same weight feel heavier.

By RaiNGE product teamUpdated 7 min read

Written for coaches adding tempo to a beginner's program for the first time.

Short answer

Tempo training for beginners starts with control of the lowering phase: write four digits (down, pause, up, pause), such as 2-0-1-0 on a goblet squat. Cut the load until the set reads RPE 6-7, keep reps low enough that every rep holds its tempo, and add a bottom pause only after two clean weeks.

  • Four digits, in seconds: lowering, pause at the bottom, lifting, pause at the top.
  • Slow reps feel heavier, so expect to lower the load first and rebuild from RPE 6-7.
  • Tempo teaches control and keeps effort honest. It is not a promise of more muscle or strength.

See a full beginner block, then decide which lift gets the first tempo. Start the 12-week beginner program

On this pageHow to read the four digits

How to read the four digits

Tempo is four numbers in seconds, written in the order the rep happens. A squat, press, or push-up starts by lowering, so its first digit is the lowering. A row or a pulldown starts by pulling, so for pulls that start by lifting, the lifting phase leads. Some programs put the lowering first on every lift, rows included, so the legend line on the sheet should say which order you use.

What each digit means, by how the rep starts.
DigitSquat, press, push-up (starts by lowering)Row, pulldown (starts by lifting)
FirstLoweringLifting, the pull
SecondPause at the bottomPause at the top, the squeeze
ThirdLiftingLowering, the return
FourthPause at the topPause at the bottom, arms long
What each digit means, by how the rep starts.
Two worked readings, as you would say them to a client.
WrittenSaid to the clientSeconds per rep
3-1-1-0Three seconds down, one-second pause at the bottom, one second up, no pause at the top5
2-0-1-0Two seconds down, straight into the lift, one second up, no pause at the top3
Two worked readings, as you would say them to a client.

A 0 means no deliberate pause. It does not mean fast: the lift should still be smooth and controlled. A 1 on the lifting phase means a steady drive, with no jerk at the start.

A four-week ladder for a first-time client

Change one thing at a time. Start with control of the lowering only, then add the bottom pause, then combine them. The sets and reps below are starting points for a goblet squat, and every one is a range to adjust.

Four weeks of tempo on one lift, with the starting sets and reps.
WeekTempoSeconds per repWhat changesSets and reps
Week 12-0-1-03Control the lowering and nothing else2-3×6-8
Week 22-0-1-03Same tempo, load rebuilt toward RPE 73×6-8
Week 32-1-1-04Add a one-second pause at the bottom3×5-6
Week 43-1-1-05Both: the longer lowering and the pause3×5-6
Four weeks of tempo on one lift, with the starting sets and reps.

Load rule. Slow reps make a familiar weight harder, so expect to lower the load until the first set reads RPE 6-7, then rebuild from there. Often that means dropping one or two dumbbell sizes. These are starting points, not exact percentages. The RPE scale guide shows how to read the rating.

Rep rule. Keep reps low enough that every rep keeps its tempo. The moment the lowering speeds up, the set is over, and the next set starts one rep lower. For most beginners that lands at 5-8 reps on a slowed set.

Where tempo helps and where it does not

Tempo suits slow, controlled lifts where the client has time to feel the position. It does not suit lifts where speed is the point, or any set where something hurts.

Use tempo on the lifts at the top of the table, and leave it off the ones at the bottom.
Lift or situationUse tempo?How to use it, or what to do instead
Goblet squatYesStart at 2-0-1-0. See goblet squat alternatives for the tempo and pause version.
Push-up regressionYesKeep the incline and write 2-0-1-0, so the lowering is the only change. The push-up regressions guide covers the ladder.
Row or pulldownYesWrite 1-1-2-0: pull for one second, squeeze for one, lower for two.
Split squatYes, with a support in reachUse 2-0-1-0 and keep a rack or wall nearby, because balance can end the set before the legs do.
Hip hinge variations, such as a dumbbell Romanian deadliftYesStart at 2-0-1-0 and lower only as far as the client keeps their position.
Kettlebell swings, jumps, and Olympic liftsNoSpeed is the point of the lift, and a count turns it into something else.
Heavy singles and near-max setsNoOne hard rep needs full attention on the lift, not on a clock.
Any set where the client is hurtingNoTempo does not fix pain. Use the pain score guide and change load, range, or the exercise.
Use tempo on the lifts at the top of the table, and leave it off the ones at the bottom.

Cue each phase, and count the first set aloud

A beginner can follow one instruction at a time. Pick one short cue per phase and keep it the same every session. Use tempo on one lift per session at first, so there is only one count to learn.

Three short cues for each phase. Pick one and repeat it.
PhaseCue 1Cue 2Cue 3
LoweringSlowly down.Take the whole count.Control it to the bottom.
Pause at the bottomHold. No bounce.Stay tight.Count one.
LiftingDrive up.Smooth, no jerk.Push the floor away.
Pause at the topStand tall.Reset.Breathe, then go.
Three short cues for each phase. Pick one and repeat it.
  1. 1

    First set: the coach counts aloud

    Say the count with the client: down, two, three, hold, up. Keep your voice level so the client copies the pace and not the volume.

  2. 2

    Second set: count only the lowering

    Call the down count, then go quiet. The client owns the pause and the lift.

  3. 3

    Third set: silent, with one note after

    Watch the set without counting and give one correction at the end. If the lowering sped up, the rep count was too high for that set.

Write tempo into the program sheet so it is read right

Give tempo its own column, write four digits with hyphens, and add one legend line to the sheet. One client who finds 3-1-1-0 in a cell with no explanation will guess.

A program sheet row with tempo in its own column.
ExerciseSets and repsTempoLoadRPE
Goblet squat3×5-62-1-1-014 kg (31 lb)7
Incline push-up3×6-82-0-1-0Bodyweight6-7
Chest-supported row3×8-101-1-2-018 kg (40 lb) per hand7
A program sheet row with tempo in its own column.

Slow reps add effort, which is why the tempo goes first on a bad day. The low-readiness guide has the rules for trimming a session. In RaiNGE, a coach reviews, edits, and approves each draft before it reaches the client, so tempo stays the coach's call to add or remove.

Worked example: one beginner's goblet squat across four weeks

This is an example, not a client result. Priya is a fictional beginner who has been doing 3×10 goblet squats at 16 kg (35 lb), untimed, at RPE 7.

Priya's goblet squat for four weeks, with the load, tempo, and effort she reported.
WeekSets and repsTempoLoadRPE
Week 13×82-0-1-012 kg (26 lb)6-7
Week 23×82-0-1-014 kg (31 lb)7
Week 33×62-1-1-014 kg (31 lb)7
Week 43×63-1-1-014 kg (31 lb)7
Priya's goblet squat for four weeks, with the load, tempo, and effort she reported.

In week 1 the old 16 kg weight read RPE 8-9 once it was lowered for two seconds, so the load dropped to 12 kg. Week 2 rebuilt it to 14 kg. In week 3 the pause went in and reps came down to 6, so that every rep kept its pause. Week 4 added the longer lowering at the same load and reps.

After week 4, Priya can return to a normal tempo and progress the load with double progression, or keep one slower set in the session as a skill check. The 12-week beginner strength program shows where a four-week tempo block fits into a first year of training.

Common questions

How slow should tempo be for a beginner?

Two to three seconds on the lowering is enough. Slower than about four seconds on any phase tends to turn into a grind, and fatigue hides technique faults. Longer counts belong in later blocks, once the client holds position through every rep of a slowed set.

Does a beginner need to count tempo out loud alone?

No. The coach counts for the first set only. After that, a metronome app set to 60 beats per minute gives one tick per second, which a client can follow at home. Drop the clock if the client loses their position while chasing the count.

Can a beginner use tempo on every exercise?

Start with one lift per session, two at most. Each tempo is a separate thing to remember, and a client who tracks four counts stops feeling the movement. Add a second tempo lift only after the first one holds without a reminder.

Next step

See a full beginner block, then decide which lift gets the first tempo.